Lotus 2 of Straws

lotus of starws

My Craft ... My Hobbies ... My Life ... My World ... !!!

    Tools and materials to make straw flowers

 

In my opinion, the most difficult types of flowers are roses manufacture, because after in scissors and in shape, straw should be behind. The first time trying to reverse it, the result is usually still ... messy. Need training to be a perfect result.

How to make:

1. 1 4-5 stems of roses require a straw. 1 straw divided into 3

2. folding two pieces of straw page..

3. Punch a hole with scissors left end and right end under straw

   

                                         
                 4. scissors suction side end portion slightly rounded towards the top left corner.

                                                        5. Results guntingannya like this.

6. If in the stretch, it looks like this.

7. Cut the shorter side leading to the hole, and not to break up, but leaving approximately 0.5 cm from the hole.

                                              8. After it in trim pleats, with a view like this

                      9. Hold the left hand right in the hole, right thumb to hold the straw that has     \                       been in a pair of scissors from the inside, and the index finger to push  

                          upwards so open and flip straw (hikz ... understand ga yah?)

                                                          10. As this happens

                                                              11. As is clearer

.

                                                       11. Do it like it at all 4 sides.

                                                               12. As this result.

                                   13. Give strokes at the ends of the petals with a straw comb     

                                           

14. Make all pieces of straw as above.

                                                   15. Prepare the pistil and the petals.

                          

                                        16. Enter the 3 pieces of petals into the pistil.

17. In the petals of the other, a pair of scissors to 4 side (see picture), but the scissors do not let the tip of the right angle, leaving about 2 inches from the point of the elbow.

18. As this happens.

          
                    19. continue to enter into the pistil petals, the flowers start to bloom visible.

20. continues to enter the petals, with intermittent, the flowers look bigger.

21. when it all, close to the lower lids.

22. So deh

Roses